Manufacturer:
Blue Hawaiian Fiberglass Pools

This pool was tiled before the deck was poured. It took 32 man hours and required 340 custom cut tiles.

Manufacturer:
San Juan Fiberglass Pools

A pool spa combination requiring 18 man hours and 150 custom cuts.

Manufacturer:
Sun Fiberglass Pools

Tiled over the lip, 30 man hours and 320 custom cuts.

Manufacturer:
Unknown

The pool was installed 3 inches out of level and required 600 custom cuts to correct the appearance.

Manufacturer:
Blue Hawaiian Fiberglass Pools

This over the lip and tiled arm took 36 hours and 330 custom tile cuts.

Manufacturer:
Unknown

This simple waterline tile job required 4 hours from start to finish.

Manufacturer:
Waterworld Fiberglass Pools

Custom cuts were installed above the seats. 36 cuts and 7 man hours were required to complete this job.

Manufacturer:
Blue Hawaiian Fiberglass Pools

The spa is tiled over the lip and marble plates are installed on the spill ways. The marble plates are water leveled to insure even water flow. This installation took 20 man hours and 120 custom cuts.

Manufacturer:
Blue Hawaiian Fiberglass Pools

The waterline tile and deck tile required 14 man hours and 70 custom cuts.

Manufacturer:
Sun Fiberglass Pools

A simple waterline tile install that required cuts above the seats and 6 hours of labor.

Manufacturer:
Aloha Hawaiian Fiberglass Pools

The entire outer circumference of the pool lip was 1 inch above the deck. Therefore, 280 pieces of quarter round trim had to be custom cut.

Manufacturer:
Unknown

This is an example of an all tiled fiberglass spa. It required 60 man hours and 800 custom cut tiles.